1. INTRODUCTION
Microplastics (MPs) accumulate in agricultural soils primarily through the use of plastic mulch films, fertilizer sacks and pesticide packaging (Campanale et al., 2024; Huang et al., 2020). Global mulch film use alone is projected to rise from 4.5 to 5.6 million tonnes by 2030 (Campanale et al., 2024), and residues left after harvest fragment under UV exposure and tillage, increasing soil MP content by up to 30% (Ren et al., 2021). Beyond physical fragmentation, weathering of PE promotes leaching of embedded additives with documented ecotoxicological effects (Bridson et al., 2023). While PE is generally considered highly persistent in soil, it is not established whether the three principal PE-based agricultural plastic streams degrade at comparable rates under identical soil conditions. We addressed this directly by exposing mulch film, fertilizer sacks and pesticide packaging to a shared factorial range of abiotic and biotic soil conditions and comparing oxidative change by FTIR.
2. MATERIALS AND METHODS
Chernozem soil, a silty clay loam typical of the Vojvodina region (Galović et al., 2023), was collected near Subotica, Vojvodina, Serbia (Figure 1), from the 10-20 cm horizon using an Eijkelkamp core sampler (SRPS ISO 10381-2:2013), then air-dried and sieved to <2 mm (ISO 11464:2004). Soil pH was measured potentiometrically in distilled water and in 1 M KCl (ISO 10390:1994); free CaCO3 was determined volumetrically (ISO 10693:1995) and organic carbon by sulfochromic oxidation (ISO 14235:1998). Particle-size distribution (coarse sand 200-2000 μm, fine sand 20-200 μm, silt 2-20 μm, clay <2 μm) was determined by combined sieving and the pipette method (Van Reeuwijk, 2002). Plant-available phosphorus was extracted with ammonium lactate (Egner et al., 1960) and quantified spectrophotometrically at 830 nm by the phosphomolybdenum-blue method (Murphy and Riley, 1962). The resulting soil was characterised as 5.17% organic matter, 2.27% CaCO3 and pH 7.27 (water) / 6.86 (KCl). Fragments (<5 mm, 100 mg) of mulch film, fertilizer sack and pesticide packaging (active compound: thifensulfuron-methyl) were incubated separately in 4 kg soil planters for four weeks under a factorial combination of temperature (20, 30, 40 °C), soil pH (7.0, 7.8, 9.0, adjusted with elemental sulfur and CaCO3, 40-day pre-incubation at 25 °C in the dark), moisture (20, 40, 60% of water-holding capacity) and UV exposure (0, 4, 8 h/day), in the presence of the native soil microbiome (Pseudomonas, Bacillus, Streptomyces, Aspergillus, Penicillium, Fusarium). Plastic residues were recovered, cleaned and analysed by diffuse-reflection FTIR (4000-400 cm-1, 4 cm-1 resolution, 60 scans per analysis). Spectra were matched against reference polymer libraries (Aldrich Polymers, Aldrich Vapor Phase and Condensed Phase Sample Libraries, HR Spectra Polymers and Plasticizers by ATR, Hummel Polymer Sample Library) using a similarity-match threshold of >60% together with the presence of at least two characteristic bands, consistent with standard FTIR library-search practice for microplastic identification (Anshari et al., 2025).

3. RESULTS AND DISCUSSION
FTIR spectra of the unused materials confirmed the expected polymer identities: mulch film showed characteristic PE bands at 2914, 2847, 1470 and 718 cm-1; fertilizer sack matched PET (2956, 1713, 1409, 1238, 1091, 1016 cm-1); and pesticide packaging matched the formulated product (bands at 2921.5, 2852.3, 1743.7, 1458.4, 1357.7, 1268.3, 1160.6 and 716 cm-1).
After four weeks of incubation, fertilizer sacks and pesticide packaging showed no new absorption bands under any of the tested temperature, pH, moisture or UV combinations, including the most extreme condition tested (40 °C, pH 9.0, 60% water-holding capacity, 8 h day-1 UV). This is consistent with reports that conventional PE-based products undergo only minimal chemical change during soil incubation (Huo et al., 2023) and that PE surface chemistry can remain largely intact even where soil biological and chemical properties are otherwise affected (Wang et al., 2022). Mulch film samples, in contrast, developed new absorption bands at 3000–3600 cm-1 and ~1000 cm-1 (Figure 2) - attributed to O–H stretching of hydroxyl-containing oxidation products and C–O stretching of the –C–O–C– functional group (Table 1), respectively-indicating early oxidative surface change (Heimowska, 2023). These signals were strongest under the combined high-stress condition (40 °C, pH 9.0, 60% water-holding capacity, 8 h day-1 UV), weaker but still detectable under moderate conditions (30 °C, pH 7.8, 40% water-holding capacity, 4 h day-1 UV), and absent under low-stress conditions (20 °C, pH 7.0, 20% water-holding capacity, no UV). This gradient points to a combined thermal, UV and moisture effect on oxidation onset, consistent with previous work showing that abiotic stressors act jointly with microbial activity to accelerate PE weathering in soil (Heimowska, 2023) and that PE surface oxidation can proceed without complete breakdown of the polymer backbone (Wahl et al., 2024).
Table 1. FTIR bands used to identify oxidative change in mulch film after soil incubation, compared with bands present in unused (pre-incubation) material.
|
Spectral region (cm-1) |
Assignment |
Present before / after incubation |
|
2914, 2847, 1470, 718 |
C–H stretching / CH₂ rocking (base PE structure) |
Present before and after |
|
3000–3600 |
O–H stretching (hydroxyl oxidation products) |
Absent before / present after (mulch film only) |
|
~1600 |
Unsaturated / oxidised C=C or C=O structures |
Absent before / present after (mulch film only) |
|
~1000 |
C–O stretching (–C–O–C–, atmospheric oxidation) |
Absent before / present after (mulch film only) |


The material-specific pattern observed here, oxidative change in mulch film but not in fertilizer sacks or pesticide packaging under identical exposure, suggests that film geometry (high surface-area-to-volume ratio, thin cross-section) rather than polymer chemistry alone governs early degradation susceptibility, since fertilizer sacks are largely PET rather than PE and pesticide packaging is a thicker HDPE-based product. This is consistent with the broader observation that PE remains among the more resistant agricultural polymers relative to PET and PP under comparable incubation (Dindar, 2025). Practically, it implies that soil microplastic monitoring and end-of-life management should not treat all PE-based agricultural plastic streams as equivalent: mulch films merit disproportionate attention given their thin geometry, large surface area and documented tendency toward early oxidative fragmentation.
4. CONCLUSIONS
Under controlled soil incubation, PE-based fertilizer sacks and pesticide packaging showed no detectable oxidative change over four weeks across a wide range of temperature, pH, moisture and UV conditions, whereas PE mulch film developed new FTIR absorption bands consistent with early-stage oxidation, most pronounced under combined high-temperature, alkaline, high-moisture and high-UV stress. These findings indicate that mulch films are disproportionately susceptible to early structural transformation among common agricultural PE plastics, supporting prioritisation of mulch-film residues in soil microplastic monitoring and in the development of biodegradable alternatives and improved end-of-life management for this specific material stream. Given the controlled, single-soil-type design of this study, field-based validation across diverse agroecological conditions is recommended as a next step.
REFERENCES
- Anshari, R., Tsuboi, M., Sato, H., Tashiro, K., & Ozaki, Y. (2025). Raman and ATR-FTIR unmask crystallinity changes and carboxylate group and vinyl group accumulation in natural weathering polypropylene microplastics. Scientific Reports, 15(1), 2518. https://doi.org/10.1038/s41598-025-85837-y
- Bridson, J. H., Abbel, R., Smith, D. A., Northcott, G. L., & Gaw, S. (2023). Release of additives and non-intentionally added substances from microplastics under environmentally relevant conditions. Environmental Advances, 12, 100359. https://doi.org/10.1016/ j.envadv.2023.100359
- Campanale, C., Galafassi, S., Di Pippo, F., Pojar, I., Massarelli, C., & Uricchio, V. F. (2024). A critical review of biodegradable plastic mulch films in agriculture: Definitions, scientific background and potential impacts. TrAC Trends in Analytical Chemistry, 170, 117391. https://doi.org/10.1016/j.trac.2023.117391
- Dindar, E. (2025). Impact of microplastic contamination on phosphorus availability, alkaline phosphatase activity, and polymer degradation in soil. Polymers, 17(12), 1586. https://doi.org/10.3390/polym17121586
- Egner, H., Riehm, H., & Domingo, W. R. (1960). Investigations on the chemical soil analysis as a basis for assessing the nutrient status of soils. II. Chemical extraction methods for phosphorus and potassium determination. Kungliga Lantbrukshögskolans Annaler, 26, 199.
- Galović, L., Husnjak, S., Šorša, A., & Martinčević, L. J. (2023). Evidence and mineralogical and physico-chemical properties of chernozem and chernozem-like soils in Croatia. Geologia Croatica, 76(3), 113-120. https://doi.org/10.4154/gc.2023.08
- Heimowska, A. (2023). Application of FTIR in analyzing microplastic contaminants in environmental samples. Environmental Science and Technology, 57(4), 1234.
- Huang, Y., Liu, Q., Jia, W., Yan, C. & Wang, J. (2020). Agricultural plastic mulching as a source of microplastics in the terrestrial environment. Environmental Pollution, 260, 114096. https://doi.org/10.1016/j.envpol.2020.114096
- Huo, Y., Dijkstra, F. A., Possell, M., Dong, A. Z., & Singh, B. (2023). Degradation of conventional, biodegradable and oxo-degradable microplastics in a soil using a δ13C technique. Soil Research, 61(8), 755. https://doi.org/10.1071/SR23140
- International Organization for Standardization (1994). Soil quality — Determination of pH (ISO 10390).
- International Organization for Standardization (1995). Soil quality — Determination of carbonate content — Volumetric method (ISO 10693).
- International Organization for Standardization (1998). Soil quality — Determination of organic carbon by sulfochromic oxidation (ISO 14235).
- International Organization for Standardization (2004). Soil quality — Pretreatment of samples for physico-chemical analysis (ISO 11464).
- Murphy, J., & Riley, J. P. (1962). A modified single solution method for the determination of phosphate in natural waters. Analytica Chimica Acta, 27, 31. https://doi.org/10.1016/S0003-2670(00)88444-5
- Ren, S., Kong, S. F., & Ni, H. G. (2021). Contribution of mulch film to microplastics in agricultural soil and surface water in China. Environmental Pollution, 291, 118218. https://doi.org/10.1016/j.envpol.2021.118227
- SRPS ISO (2013). Soil quality — Sampling — Part 2: Guidance on sampling techniques (ISO 10381-2:2013).
- Van Reeuwijk, L. P. (2002). Procedures for soil analysis (6th ed.). ISRIC — World Soil Information.
- Wahl, A., Davranche, M., Rabiller-Baudry, M., Pedrot, M., Khatib, I., Labinne, F., Cante, M., Cuisinier, C., & Gigault, J. (2024). Condition of composted microplastics after they have been buried for 30 years: Vertical distribution in the soil and degree of degradation. Journal of Hazardous Materials, 462, 132686. https://doi.org/10.1016/j.jhazmat.2023.132686
- Wang, F., Wang, Q., Adams, C. A., Sun, Y., & Zhang, S. (2022). Effects of microplastics on soil properties: Current knowledge and future perspectives. Journal of Hazardous Materials, 424, 127531. https://doi.org/10.1016/j.jhazmat.2021.127531